HP Insight Management-Software - Manual (Page 143)

Displaying factory default MAC and WWN addresses
NOTE: There is not any label or attribute indicating that the MAC or WWN addresses displayed
are factory defaults, it is up to you to identify that.
For VC firmware 3.7x and later, you can view factory default MAC and WWN addresses for:
•
The server profile edit page for assigned server profiles
•
The server profile edit page for unassigned server profiles
•
Each server profile edit page with Advanced Settings
•
Imported server profiles from VCM with mixed connections (user-defined and factory default).
•
The Server Profile Information details link
Figure 89 (page 143) shows the Server Profile Information details link
Figure 89 Server Profile Information details
NOTE: Factory default address information is only available for mapped connections.
Connections which are unmapped will continue to display as Factory-Default.
Deleting WWN exclusion ranges
1. From the VCEM home page, under the Administration heading, click the World Wide Names
hyperlink.
2. From the Select ranges to configure list, select WWN.
3. Select a WWN address range. The exclusion range must be contained within the address
range to which the exclusion range belongs.
4. Click Delete. You are prompted to confirm your choice.
IMPORTANT: If the exclusion range includes external addresses, these external addresses
remain external, even if the exclusion range is removed.
To avoid conflicts, ensure all addresses within this range are not being used by any other
Fibre Channel device on your network.
Deleting WWN exclusion ranges 143