Reclaiming external wwn addresses, Adding a custom wwn address range, Editing a custom wwn address range – HP Insight Management-Software User Manual
Page 144: Deleting a custom wwn address range
Reclaiming external WWN addresses
When a VC Domain containing server profiles is removed from a VC Domain Group configured
to use User-Defined WWN address ranges, VCEM reclassifies the WWN addresses in the removed
VC Domain as external. This does not change the actual addresses for server profiles in the VC
Domain. Addresses identified as external are reserved for VC Domains outside of VCEM and will
not be used by VCEM.
To change the status of an address from External to Free, use the Reclaim External button. Before
freeing an address, verify that the address is no longer used by a VC Domain outside of VCEM.
To reclaim WWN addresses:
1.
From the Virtual Connect Enterprise Manager home page, under the Administration heading,
click the World Wide Names hyperlink.
2.
From the Select ranges to configure list, select WWN. The WWN Ranges List page appears.
3.
Select a WWN address range.
4.
Click the Individual addresses tab.
5.
From the Filter list, select External.
6.
Select the external addresses.
7.
Click Reclaim External. You are prompted to confirm your choices.
8.
Click OK.
Adding a custom WWN address range
Because the maximum range size is 131,072, a large range might take a few minutes to create.
You can create one custom range.
To add WWN a custom address ranges:
1.
From the Virtual Connect Enterprise Manager home page, under the Administration heading,
click the World Wide Names hyperlink.
2.
From the Select ranges to configure link, select WWN.
3.
Click Add custom. The Add Custom WWN Address Range information appears.
4.
Enter the custom WWN address range.
5.
Click OK.
Editing a custom WWN address range
Because the maximum range size is 131,072, a large range might take a few minutes to edit. You
can create one custom range.
1.
From the VCEM home page, under the Administration heading, click the World Wide Names
hyperlink.
2.
From the Select ranges to configure link, select WWN.
3.
Select a WWN address range.
4.
Click Edit.
5.
Edit the WWN address range as necessary. Valid WWN ranges cannot contain all 0s or all
Fs and cannot have an F within either of the first two octets.
6.
Click OK.
Deleting a custom WWN address range
NOTE:
Removing a custom WWN address range also removes its defined exclusion ranges.
1.
From the Select ranges to configure link, select WWN.
2.
Select the custom WWN range.
3.
Click Delete. You are prompted to confirm your choice.
144 Managing MAC and WWN addresses