Viewing vc domain details, Viewing vc domain qos details – HP Insight Management-Software User Manual
Page 63
Changes in VCM that might cause problems in completing VC Domain Maintenance include:
•
Updating the VC firmware to an incompatible version, (Domain Settings
→Firmware
Management). To resolve this issue, update the VC firmware version to a compatible version
and complete VC Domain Maintenance again.
•
Deleting the domain (Domain Settings
→Domain Configuration). To resolve this issue, restore
the VC configuration from a backup, or remove the VC Domain from the VC Domain Group.
•
Breaking the VC lock by using the VC command line. To resolve this issue, remove the VC
Domain from the VC Domain Group.
•
VC fails to respond. If the VC Domain Maintenance job fails due to poor or failed VC
communication, fix the communication issue and complete VC Domain Maintenance again.
Viewing VC Domain details
NOTE:
For QoS, operation permissions and multicast filters, details are only available if the VC
Firmware is 4.0x or later.
VCEM has enhanced how VC Domain details are displayed. VCEM provides a tab for each VC
Domain component such as Ethernet networks, shared uplink sets, and FC SAN fabrics. You can
also view new tabs such as quality of service (QoS), operation permissions, and multicast filters.
To access VC Domain details and component detail tabs, click on the VC Domain you want to
view and depending upon your configuration, VC Domain details similar to
appear.
Figure 31 VC Domain details
Viewing VC Domain QoS details
To view QoS information on the VC Domain details page, select the QoS tab and the appropriate
OoS is displayed.
and
displays each QoS type.
NOTE:
QoS settings are only displayed in both the VC Domain and VC Domain Group details
in VCEM. For more information on configuring QoS see the
HP Virtual Connect for c-Class BladeSystem User Guide at
VC Domain Maintenance
63