HP XP Command View Advanced Edition Software User Manual
Page 488
Point-in-time restoration when not using the SCR seed function
This section gives an example of how to perform a point-in-time restoration on a storage group, using
backed up data that was acquired in an SCR configuration, and without using the SCR seed function.
This example uses the backup data acquired in “
Backing up in an SCR configuration
1.
From the backup server, start the Protection Manager service.
2.
From the backup server, check the backup ID of the tape device.
PROMPT> drmtapecat
BACKUP-ID BACKUP-OBJECT SNAPSHOT TIME EXPIRATION TIME BACKUP-MEDIA
0000000002 MSEXCHANGE 2002/06/01 11:00:00 2002/06/02 11:00:00 MEDIA1
PROMPT>
3.
From the backup server, mount the secondary volume to restore data from the tape device.
Specify the backup ID
0000000002
, and then execute the
drmmount
command.
PROMPT> drmmount 0000000002 -mount_pt W:
KAVX0001-I The drmmount command will now start.
KAVX0400-I Mounting will now start.
Mount point = W:
KAVX0401-I Mounting has finished.
Mount point = W:
KAVX0400-I Mounting will now start.
Mount point = X:
KAVX0401-I Mounting has finished.
Mount point = X:
KAVX0002-I The drmmount command will now end.
PROMPT>
4.
From the backup server, restore the backup data from the tape device to the secondary volume.
Specify the backup ID
0000000002
, and then execute the
drmmediarestore
command.
The backup ID
0000000001
is deleted and a new backup ID (
0000000003
) is assigned and
registered into the backup catalog.
PROMPT> drmmediarestore 0000000002
KAVX0001-I The drmmediarestore command will now start.
KAVX0404-I Restoration will now start.
To see more details on restoration progress, use the monitoring method of
the backup management product.
Source = W:
Target = W:
KAVX0404-I Restoration will now start.
To see more details on restoration progress, use the monitoring method of
the backup management product.
Source = X:
Target = X:
KAVX0405-I Restoration has finished.
Source = W:
Target = W:
KAVX0405-I Restoration has finished.
Source = X:
Target = X:
KAVX0040-I The backup ID has been assigned as follows:
Backup ID = 0000000003
KAVX0002-I The drmmediarestore command will now end.
PROMPT>
Operation for Exchange databases
488