HP 8.20q Fibre Channel Switch User Manual
Page 51
8/20q Fibre Channel Switch QuickTools switch management user guide
51
Operational State
Switch operational state: Online, Offline, Diagnostic, Down
Administrative State
Current switch administrative state
Configured Admin State
Administrative state that is stored in the switch configuration
Beacon Status
Beacon status. Switch LEDs are blinking (On) or not blinking
(Off).
Reason for Status
The reason for the operational state.
Temperature
Internal switch temperature °C
Power Supply 1 Status
Whether the switch is On or Off
Temperature Failure Port
Shutdown
Non-configurable (always enabled for this switch). All ports
are shut down when the switch temperature exceeds the
Failure Temperature.
Warning Temperature
Non-configurable temperature threshold (65° C), above
which a warning condition alarm is generated.
Failure Temperature
Non-configurable temperature threshold (70° C), above
which a failure condition alarm is generated.
POST Status
The current diagnostic state of the switch.
POST Fault Code
The code value for the last recorded diagnostic test result
recorded on the switch.
Test Status
The current diagnostic test status of switch.
Test Fault Code
The code value for the last recorded diagnostic test status
recorded on the switch.
Network Group
IPv4 Enabled
Internet Protocol version 4 Enabled or Disabled
IPv4 Address
Internet Protocol version 4 address
IPv4 Subnet Mask
Mask that determines the IP address subnet
IPv4 Gateway
Gateway address
IPv6 Enabled
Internet Protocol version 6 Enabled or Disabled
IPv6 Address
Mask that determines the IP address subnet
IPv6 Gateway
Gateway address
SNMP Enabled
SNMP Enabled or Disabled
SNMP v3 Security Enabled SNMP v3 Security Enabled or Disabled
Broadcast Support
Broadcast support status. Broadcast support is enabled
(default) or disabled.
NTP Client Enabled
NTP Client Enabled or Disabled. If Enabled, this parameter
allows switches to synchronize their time to a centralized
server.
NTP Server Address
The IP address of the centralized NTP server. Ethernet
connection to NTP server is required.
DNS Enabled
Domain Name Service Enabled or Disabled
Table 9
Switch data window fields
Field
Description