HP LaserJet 5200 Printer series - Manual (Page 60)

Controlling print jobs
In Windows, three settings affect how the printer driver pulls media when you send a print job. The
Source, Type, and Size settings appear in the Page Setup, Print, or Print Properties dialog boxes in
most software programs. If you do not change these settings, the printer automatically uses the default
printer settings to select a tray.
CAUTION: Make printer setup changes through the software program or the printer driver whenever
possible, because changes that you make at the control panel become default settings for subsequent
print jobs. Settings selected in the software or the printer driver override control-panel settings.
Source
Print by Source to specify a tray from which the printer will pull media. The printer tries to print from this
tray, no matter what type or size is loaded in it. If you select a tray that is configured for a type or size
that does not match your print job, the job does not proceed until you load the tray with the correct type
or size. If you load the tray correctly, the printer begins printing. If you press , you can select another
tray.
NOTE: If you have difficulties printing by Source, see Priority for print settings on page 48 .
Type and Size
Print by Type or Size when you want to pull media from the first tray that is loaded with the type or size
that you select. Selecting media by type rather than source is similar to locking out trays and helps
protect special media from accidental use. For example, if a tray is configured for letterhead, and you
specify that the driver print on plain paper, the printer will not pull media from that tray, but will pull paper
from a tray that has plain paper loaded and is configured for plain paper.
NOTE: Selecting the Any setting negates the tray lock-out function.
Selecting media by type and size results in significantly better print quality for heavy paper, glossy paper,
and overhead transparencies. Using the wrong setting can result in unsatisfactory print quality. Always
print by Type for special print media, such as labels or transparencies. Always print by Size for
envelopes.
● If you want to print by Type or Size and the trays have not been configured for a certain type or
size, load the media into tray 1. Then, in the printer driver, select the Type or Size in the Page
Setup, Print, or Print Properties dialog box.
● If you often print on a certain type or size of media, you can configure a tray for that type or size.
Then, when you select that type or size as you print a job, the printer pulls from the tray configured
for that type or size.
● When you close tray 2, a message might appear prompting you to select a Type or Size for the
tray. If the tray is already configured correctly, press to return to the Ready state.
NOTE: If all of the tray type settings are set to ANY, and if you do not select a specific tray (source)
in the printer driver, the printer pulls media from the lowest tray. For example, tray 2 is loaded, the printer
pulls media from that tray first. However, if the tray 1 size and type settings are set to ANY and if media
is loaded in the tray, then the printer prints from tray 1 first. If tray 1 is closed, the printer prints from
tray 2.
Priority for print settings
Changes to print settings are prioritized depending on where the changes are made:
48 Chapter 4 Printing tasks ENWW