Enww control-panel messages 109 – HP LaserJet 5200 Printer series User Manual
Page 121

Control panel message
Description
Recommended action
Tray size cannot be ANY SIZE/ANY
CUSTOM
BAD DUPLEXER CONNECTION
alternates with
To continue turn off then on
The duplexer is not installed correctly.
Turn the printer off and then on to continue.
Calibrating...
The printer is calibrating.
No action necessary.
Canceling...
The printer is in the process of canceling a
job. The message appears while the job is
stopped, the paper path is flushed, and any
remaining incoming data on the active data
channel is received and discarded.
No action necessary.
Checking paper path
The engine is turning the rollers to check for
possible jams.
No action necessary.
Checking printer
The engine is performing an internal test.
No action necessary.
CHOSEN PERSONALITY NOT
AVAILABLE
alternates with
To continue press
The printer encountered a request for a
personality that did not exist in the printer.
The job is cancelled and no pages are
printed.
1.
Press
to continue.
2.
Try a different driver.
CLEANING DISK X% COMPLETE
alternates with
DO NOT POWER OFF
The memory disk is being cleaned. This
process might take up to an hour. During this
time, no jobs can be printed.
Do not turn off the printer. Wait for the
process to complete.
The printer automatically restarts at the end
of the cleaning process.
Cleaning...
The printer is processing the cleaning page.
No action necessary.
Clearing event log
This message appears while the event log is
cleared. The printer then returns to the
SERVICE menu.
No action necessary.
Clearing paper path
The printer jammed or detected misplaced
media. The printer is attempting to eject these
pages automatically.
No action necessary.
CLOSE TOP COVER AND FRONT DOOR
The top cover and front door need to be
closed.
Close the top cover and front door.
CODE CRC ERROR
An error has occurred during a firmware
upgrade.
1.
Reinstall the firmware.
2.
If the problem persists, contact
HP Support.
Creating...CLEANING PAGE
The printer is generating a cleaning page.
The printer returns to the Ready state after
the cleaning page is printed.
1.
Load the cleaning page into tray 1.
2.
Press
Menu
.
3.
Select PRINT QUALITY, and then press
.
4.
Select PROCESS CLEANING PAGE,
and then press
.
ENWW
Control-panel messages 109