108 chapter 7 problem solving enww – HP LaserJet 5200 Printer series User Manual
Page 120

Control panel message
Description
Recommended action
To continue turn off then on
68.X PERMANENT STORAGE FULL
alternates with
To continue press
A non-volatile storage device is full. Press
to clear the message. Printing can
continue, but unexpected behavior could
result.
X Description
0 Onboard NVRAM
1.
Press
to continue.
2.
For 68.0 errors, turn the printer off and
then on.
3.
If a 68.0 error persists, contact
HP Support.
68.X PERMANENT STORAGE WRITE FAIL
alternates with
To continue press
A non-volatile storage device is full. Press
to clear the message. Printing can
continue, but unexpected behavior could
result.
X Description
0 Onboard NVRAM
1.
Press
to continue.
2.
If the problem persists, contact
HP Support.
68.X STORAGE ERROR SETTINGS
CHANGED
alternates with
To continue press
A non-volatile storage device is full. Press
to clear the message. Printing can
continue, but unexpected behavior could
result.
X Description
0 Onboard NVRAM
1.
Press
to view step-by-step
information.
2.
To clear the error, press to exit the
message, and then press
to
continue.
3.
If the problem persists, turn the printer
off and then on.
4.
If the message persists, contact
HP Support.
5.
To exit, press .
79.XXXX ERROR
alternates with
To continue turn off then on
A critical hardware error has occurred.
1.
Turn the printer off and then on.
2.
If the problem persists, contact
HP Support.
To change press
To skip, press STOP
The printer has an internal clock that tracks
the date and time. You are prompted to set
the correct date and time the first time you
turn on the printer.
Press
to change the date and time.
Press
Stop
to skip this step. You can set the
date and time later by using the SYSTEM
SETUP menu.
If the prompt appears each time you turn on
the printer, the clock is not working correctly.
Contact HP support.
Access Denied MENUS LOCKED
The printer administrator has enabled the
control-panel security mechanism. You
cannot modify control-panel settings in this
circumstance. The message disappears after
a few seconds, and the printer returns to
Ready or BUSY state.
Contact the printer administrator to change
settings.
ACTION NOT CURRENTLY AVAILABLE
ON TRAY X
alternates with
You are trying to set duplex registration for a
tray that is configured for ANY SIZE or ANY
CUSTOM. Duplex registration is not available
when the tray size is set to either of these
settings.
Change the size setting for the tray.
108 Chapter 7 Problem solving
ENWW