HP ProLiant DL320e Gen8 Server - Manual (Page 61)

1. In the iLO Configuration Utility window, click Network Settings. The General tab data appears.
2. Edit the setting(s) as required. Click Apply.
Network Settings–IPv4
•
Enable DHCPv4—Enables iLO to obtain its IP address (and many other settings) from a DHCP
server.
◦ Use DHCPv4 Supplied Gateway—Specifies whether iLO uses the DHCP server-supplied
gateway. If DHCP is not used, enter a gateway address in the Gateway IPv4 Address
box.
◦ Use DHCPv4 Supplied Static Routes—Specifies whether iLO uses the DHCP server-supplied
static routes. If not, enter the static route destination, mask, and gateway addresses in
the Static Route #1, Static Route #2, and Static Route #3 boxes.
◦ Use DHCPv4 Supplied Domain Name—Specifies whether iLO uses the DHCP server-supplied
domain name. If DHCP is not used, enter a domain name in the Domain Name box on
the Shared Network Port page.
◦ Use DHCPv4 Supplied DNS Servers—Specifies whether iLO uses the DHCP server-supplied
DNS server list. If not, enter the DNS server addresses in the Primary DNS Server,
Secondary DNS Server, and Tertiary DNS Server boxes.
◦ Use DHCPv4 Supplied Time Settings—Specifies whether iLO uses the DHCPv4
server-supplied time.
◦ Use DHCPv4 Supplied WNS Servers—Specifies whether iLO uses the DHCP server-supplied
WINS server list. If not, enter the WINS server addresses in the Primary WINS Server
and Secondary WINS Server boxes.
•
IPv4 Address—The iLO IP address. If DHCP is used, the iLO IP address is supplied automatically.
If DHCP is not used, enter a static IP address.
Performing maintenance 61