Canon EOS C300 PL - Manual (Page 75)

75
Setting the Time Code
NOTES
• When [w Other Functions] > [24.00P] is set to [On] or [w Other Functions] > [Frame Rate] is set to
[23.98P], the frames value in the time code runs from 0 to 23. When [Frame Rate] is set to [25.00P], [50.00i] or
[50.00P], it runs from 0 to 24. For other [Frame Rate] settings, it runs from 0 to 29.
• When you are using interval recording, frame recording or slow & fast motion recording mode, you cannot
select the [Free Run] running mode. Conversely, when you are using pre-recording mode, [Free Run] is set
automatically and cannot be changed.
• When you mix drop frame and non-drop frame time codes, there might be a discontinuity in the time code at
the point where the recording starts.
• As long as the built-in rechargeable lithium battery is charged and you selected the [Free Run] running mode,
the time code continues to run even if you disconnect all other power sources. However, this is less accurate
than when the camcorder is on.
• If you set an assignable button to [Time Code] (A 99), you can press the button to open the [¤ TC/UB
Setup] > [Time Code] submenu.
COP
Y