Canon EOS C300 PL - Manual (Page 46)

Adjusting the Black Balance
46
Adjusting the Black Balance
You can have the camcorder adjust the black balance automatically when ambient temperature changes
considerably or if there is a noticeable change in a true black video signal.
1 Open the [ABB] screen.
[~ Camera Setup] > [ABB]
2 Attach the body cap to the lens mount.
• If a lens was attached, remove the lens and replace the body cap.
3 Select [OK] and then press SET.
• The automatic black balance procedure will start.
4 When the confirmation message appears, press SET.
• If the body cap is not correctly attached, [Error] will appear on the screen. Press SET and repeat the
procedure from the beginning.
NOTES
• Adjusting the black balance may be necessary in the following cases:
- When using the camcorder for the very first time or after a long period of not using it.
- After sudden or extreme changes in ambient temperature.
- After changing the ISO speed/gain settings.
• The automatic black balance procedure will take approximately 40 seconds when the frame rate is set to
23.98P or 24.00P.
• During the adjustment of the black balance, you may notice some irregular displays appear on the screen. This
is not a malfunction.
• Resetting the camcorder’s settings using the [w Other Functions] > [Reset] > [All Settings] or [Camera
Settings] menu option will reset also the black balance adjustment. In such case, perform the procedure again.
Operating modes:
[~ Camera Setup]
[ABB]
COP
Y