Agilent Technologies E8247C PSG CW - Manual (Page 43)

Chapter 2 33
Basic Operation
Configuring the RF Output
11. Press
Return
>
Sweep
>
Freq & Ampl
.
This sets the step sweep to sweep both frequency and amplitude data. Selecting this softkey returns you
to the previous menu and turns on the sweep function.
12. Press
RF On/Off
.
The display annunciator changes from RF OFF to RF ON .
13. Press
Single Sweep
.
A single sweep of the frequencies and amplitudes configured in the step sweep is executed and available
at the RF OUTPUT connector. On the display, the
SWEEP annunciator appears for the duration of the
sweep and a progress bar shows the progression of the sweep. The
Single Sweep
softkey can also be used
to abort a sweep in progress. To see the frequencies sweep again, press Single Sweep to trigger the
sweep.
To Configure a Continuous Step Sweep
Press
Sweep Repeat Single Cont
.
This toggles the sweep from single to continuous. A continuous repetition of the frequencies and amplitudes
configured in the step sweep are now available at the RF OUTPUT connector. The
SWEEP annunciator
appears on the display, indicating that the signal generator is sweeping and progression of the sweep is
shown by a progress bar.