PNI TCM 2.6 - Manual (Page 32)

PNI Sensor Corporation DOC#1009269 r11
TCM2.5 & TCM2.6 User Manual Page 32 of 49
User Configuration Parameter Commands
The following commands allow you to set and query the values of the TCM2.5/2.6’s user configura-
tion parameters. These parameters specify how the TCM2.5/2.6 will operate, such as damping,
baud rate, and so on. The TCM2.5/2.6 stores all parameter values in EEPROM when specified, so
that after a reboot or power cycling, it will return to the last configuration set. Note that any parame-
ter that specifies a numeric value must be specified with the appropriate units of the current setting.
b= (Set Baud Rate)
Description Sets the baud rate for the RS232 interface. Note: This is now an immediate
command and a reset is no longer required.
Syntax b=n
Output :
Valid Values
Input Baud Rate
1 300
2 1200
3 2400
4 4800
5 9600 (default setting)
6 19200
7 38400
8 115200
Table 9: Valid b= Values
Example b=5 !set baud rate to 9600 baud
:
Query Response b? :b=