PNI TCM 2.6 User Manual
Page 22
PNI Sensor Corporation
DOC#1009269 r11
TCM2.5 & TCM2.6 User Manual
Page 22 of 49
Command differences between the TCM2.5/2.6 and previous TCM2 units
To keep the software compatible with existing systems, when any of the commands below are sent
the unit will respond with the “:” as if it had accepted the command. Querying the command will
result in an error code, since the command is obsolete and not being used.
Command
Description
Commands not used for the TCM2.5/2.6
autocal
Autocalibration
%skip=
Skip measurements
cclip=
Set Clip Value
clock=
Set Clock rate
ed=
Enable Magnetic Distortion Alarm
fast=
Enable Fast Sampling
sao=
Select Analog Output Option
save
Unit automatically saves any changed settings
seriallp=
Lower Power Serial Consumption (specific to older chip)
Table 6: TCM2 vs TCM2.5/2.6 Commands