PNI TCM 2.6 - Manual (Page 28)

PNI Sensor Corporation DOC#1009269 r11
TCM2.5 & TCM2.6 User Manual Page 28 of 49
factory (Factory Settings)
Description Resets the TCM2.5/2.6 to the factory settings. The internal modes are set to the
following factory defaults
b=5 er=e mpcal=d ut=c
cc et=d sdo=t
damping=d timeconst=8 sn=m
ec=e halt=d sp=8
em=d ma=u uc=d
ep=e mag_dec=0.0 ui=d
Syntax factory
Output H0V0m0.00
Example factory
go (Enter Continuous Sampling Mode)
Description Enters the Continuous Sampling Mode (go). The TCM2.5/2.6 immediately begins
outputting sensors data at rate specified by the SP parameter, default is 8 Hz. Data is
automatically transmitted according to the Output Word Format (sdo=) currently
specified. To exit the TCM2.5/2.6 and return to Standby mode, issue the Halt
Continuous Sampling (h) command.
Syntax
go
Output
Selected data output word.
Example
go
Related Commands
s? (Single Update of Output Word)
h (Halt Continuous Sampling)