PNI TCM 2.6 - Manual (Page 27)

PNI Sensor Corporation DOC#1009269 r11
TCM2.5 & TCM2.6 User Manual Page 27 of 49
Related Commands et= (Enable Temperature)
ut= (Set Temperature Units)
Action Commands
? (Help Command)
Description All TCM2.5/2.6 commands are displayed using the “?” command.
cc (Clear Calibration Data)
Description Erases all calibration data. Any further magnetometer or compass output is not
corrected for any local fields. This command is only valid during Standby Mode (h).
Use this command before recalibrating the TCM2.5/2.6 for a new or changed local
magnetic environment.
Syntax cc
Output HnVnMn.nn
Example cc
H0V0M0.00
Query Response lc? (Last Calibration Score)
Related Commands mpcal= (Multipoint Calibration)
c? (Compass Update)