PNI TCM 2.6 - Manual (Page 29)

PNI Sensor Corporation DOC#1009269 r11
TCM2.5 & TCM2.6 User Manual Page 29 of 49
h (Halt Continuous Sampling, Enter Standby)
Description Exits Continuous Sampling Mode (go) and enters Standby mode (h). If this
command is received while the TCM2.5/2.6 is transmitting an output word, the
remainder of the output word will be sent before the TCM2.5/2.6 changes modes.
Syntax
h
Output
:[Ennn]
Related Commands
go (Enter Continuous Sampling Mode)
halt= (Enable Single Character Halt)
halt= (Enable Single Character Halt)
Description The halt command during go mode has optionally been made a single character
command using the halt=e command.
Syntax halt=d
Output :[Ennn]
Valid Values
Input Description
e Enable, h command for halting the ouput
d h command for halting the output (default setting)
Table 7: Valid halt= Values
Query Response halt? :halt=
Related Commands go (Enter Continuous Sampling Mode)