PNI TCM 2.6 - Manual (Page 31)

PNI Sensor Corporation DOC#1009269 r11
TCM2.5 & TCM2.6 User Manual Page 31 of 49
sleep (Sleep Mode)
Description Enters the sleep mode of operation. This command turns off the internal clocks and
the RS-232 chip.
Syntax sleep
Output
Example
Related Commands wake (Wake Mode)
wake (Wake Mode)
Note: Only used with the TCM2.5
Description Enters the wake mode of operation. To wake the TCM2.5, a falling edge on the int2
(interrupt 2) pin of the processor is required. This is achieved by connecting pin 6
of the TCM2.5 connector to the RTS pin (pin 4 on a DB25 and pin 7 on a DB9) of
the COM port.
A sample wake.c program example is provided at the end of this document. To
wake the TCM2.6, toggle RxD line
Syntax wake
Output
Example
Related Commands sleep (Sleep Mode)