Alcatel Carrier Internetworking Solutions SpeedTouch Speed Touch Home Asymmetric Digital Subscriber Line (ADSL) Modem - Manual (Page 42)

6 Lost Speed Touch Home
42 / 88
3EC 17058 AAAA TCZZA Ed. 02
5. You must clear the entry in the ARP cache by issuing
the following command :
arp –d
Note The IP address used to perform a PingĆtoĆDefaults  is not
assimilated by your STHome. The STHome will restart with the
original defaults, including the default IP address 10.0.0.138.
6. If needed, reconfigure the STHome's IP address.
6.2.2 Push Button
The small push button entitled "Defaults" is located on the rear panel
of the STHome.
The procedure to revert all of the STHome configurable values back
to their manufacturing defaults is as follows:
1. Make sure the STHome is powered on.
2. Use a pencil to press the push button at the back of the STHome.
3. Release the button. Via the flashing front panel LEDs, you will
notice that the STHome will restart.
4. Finally, it will come online with default settings.
5. If needed, reconfigure STHome's IP address.