Alcatel Carrier Internetworking Solutions SpeedTouch Speed Touch Home Asymmetric Digital Subscriber Line (ADSL) Modem - Manual (Page 41)

6 Lost Speed Touch Home
41 / 88
3EC 17058 AAAA TCZZA Ed. 02
6.2 Set to Manufacturing Defaults
The following procedures will reset all of the Speed Touch  Home's
configurable values back to their defaults, including the IP address.
CAUTION
PingĆtoĆDefaults  and Push button vs. Internal Settings
Be careful when using the PingĆtoĆDefaults  command, or the push
button as it destroys all changes previously made to the STHome
internal settings.
Note A reset to defaults, also implies the STHome's IP address is
permanent reset to 10.0.0.138. It is possible that your STHome
needs another IP address according your LAN configuration.
Therefore, you may have to execute a PingĆofĆLife  .
6.2.1 PingĆtoĆDefaults
The first method to reset all settings to the original defaults is
the PingĆtoĆDefaults  .
The technique is identical to that used for the PingĆofĆLife  , except
that another MAC address is used, i.e.
01–90–D0–80–01–FF
.
The following steps will cause the Speed Touch  Home to revert to
the default values:
1. Power off the STHome.
2. Add the following to the ARP cache:
arp –s 01-90-D0-80-01-FF
This can be any address
within your subnet as long as it is not used by any other member
of your local network.
3. Power on the STHome and wait for the POST to end.
4. Ping this same IP address :
ping