Milestone XProtect Essential 2014 - Manual (Page 85)

Milestone XProtect ® Essential 2014 Administrator's Manual
www.milestonesys.com 85 Advanced configuration
Name Description
Clear All Click button to clear all selections in the Apply Template column.
Set selected template value on
selected cameras
Apply only a selected value from the template to selected cameras.
Set all template values on
selected cameras
Apply all values from the template to selected cameras.
Properties available in XProtect Enterprise and XProtect Professional only:
Record Keyframe Only
Keyframes stored at specified intervals record the entire view of the
camera, whereas the following frames record only pixels that
change; this helps greatly reduce the size of MPEG files. Select the
check box if you only want to record keyframes.
Record All Frames on
Allows you to make exceptions if you have selected to record
keyframes only.

Motion Detection: Select this to record all frames when
motion is detected. Two seconds after the last motion (see
"Motion detection & exclude regions" on page 97) is
detected, the camera will return to recording keyframes
only.

Event: Select this to record all frames when an event
occurs and until another event occurs. Requires that events
(see "Overview of events and output" on page 107) have
been defined, and that you select start and stop events in
the neighboring columns.
Use the Configure events list, located below the other
fields to define events that suit your needs.

Motion Detection & Event: Select this to record all frames
when motion is detected, or when an event occurs and until
another event occurs. Remember to select start and stop
events in the neighboring columns.

Schedule only: Select this to record all frames according to
the camera's speedup schedule (see "Speedup" on page
126) only.
Start Event
Use when recording on Event or Motion Detection & Event.
Select required start event. The camera will begin recording all
frames when the start event occurs.
Stop Event
Select required stop event. The camera will again only recording
keyframes when the stop event occurs.
Audio selection
When you configure video and recording (see "About video and recording configuration" on page 65),
you can specify certain properties for many cameras in one go. Either in order to speed up things, or