Dwyer TIC - Manual (Page 42)

41
About the analysis settings
*Alert
There are two kinds of temp-alert:
Upper-limit alert and Lower-limit alert.
1.Upper-limit alert
Set item "alert" as [on], and "Capture spot" as
[maximum], then spot analysis tool "max sp10" will
automatically capture the hottest spot within the
screen, if this temperature is higher than the value
you set in "alert temp", the reading on top-right
screen will turn into RED,and a beeping sound will
be heard also.
2.Lower-limit alert
Set item "alert" as [on], and "Capture spot" as
[minimum], then spot analysis tool "mini sp10" will
automatically capture the coldest temperature
within the screen, if this temperature is lower than
the value you set in "alert temp", the reading on
top-right screen will turn into RED, and a beeping
sound will be heard also.
Note
:select spot analysis tools [capture max.] &
[capture min.] in menu "Analysis".
*Alert Temp
Sets the temperature limit of “Alert”.
Correct
Temp
Corrects the measured temperature value of the
camera to ensure the measurement accuracy
under special circumstances.
Saturation
Color
When it’s on, Green will take place of the color that
stands for the highest temperature.
*Isotherm
Width
Sets the width of isothermal interval. The width can
be adjusted from 0.1℃ to the upper limit of the
maximum temperature measurement range under
this condition.
*Isotherm
Color
Sets the color of the isotherm interval. Transparent,
Green, Black and White are available.