Badger Meter Model IOG User Manual
User manual, Display, Badger meter
Table of contents
Document Outline
- Figure 1: ER-500 monitor
- Figure 2: Model number construction
- Figure 3: ER-500 Dimensions
- Figure 4: Input jumper settings
- Figure 5: Typical IOG meter input connection
- Figure 6: Loop power connections
- Figure 7: Run mode display annunciators
- Figure 8: Keypad detail
- Figure 9: Programming mode display
- Figure 10: Test mode screen
- Figure 11: Instantaneous flow rate and current total
- Figure 12: Grand total
- Figure 13: Open drain connections
- Figure 14: Opto-isolated open collector connections
- Figure 15: 4-20 mA calibration setup
- Figure 16: Set point output
- Figure 17: Typical solid state relay connections
- Figure 18: Set point actions
- Figure 19: Set point example
- Figure 20: Hardware reset
- Figure 21: Opening the ER-500
- Figure 22: Battery connection release.
- INTRODUCTION
- Model Numbers
- Dimensions
- Specifications
- INSTALLATION
- OPERATING THE MONITOR
- PROGRAMMING
- APPENDIX
- Troubleshooting Guide
- Battery Replacement