Airedale BluCube 10-48kW - Manual (Page 9)

Condensing Units BluCube
™
Condensing Units
9
Installation and Maintenance Manual 7222094: 11/2013
Installation Data
Lifting Whenever a condensing unit is lifted, it should be from the base and, where possible, with
all packing and protection in position. If slings are used care should be taken to ensure
that the slings do not crush the casework or coil. The slings are to be located into the
recess within the unit frame to ensure safe lifting.
Due note should also be made of the fact that the compressor is at one end of the unit,
and therefore the centre of gravity will also be towards that end.
If the unit is dropped, it should immediately be checked for damage.
Employ lifting specialists
Local codes and regulations relating to the lifting of this type of equipment should
be observed
Use the appropriate spreader bars/lifting slings with the holes/lugs provided
Chains/slings MUST NOT interfere with the casing of fan assembly to avoid damage
Lift the unit slowly and evenly
IMPORTANT If the unit is dropped, it should immediately be checked for damage and reported
to Airedale.
CAUTION Only use lifting points provided.
Ensure drip tray is removed before lifting (Heat Pump units only)
Cut-out size ???mm x ???mm
Minimum lifting chain
length of 1500mm
Sling Length 4500mm