West Control Solutions KS 50-1 - Manual (Page 49)

PAr.2
Name Value range Description Default
Pb12 1...9999 1 Proportional band 1 (heating) in phys. dimensions (
e.g. °C), 2. parameter set
100
Pb22
1...9999 1 Proportional band 2 (cooling) in phys. Dimensions
(e.g. °C), 2. parameter set
100
Ti22 0...9999 Integral action time 2 (cooling) [s], 2. parameter set 180
Ti12
0...9999 Integral action time 1 (heating) [s], 2. parameter set 180
Td12
0...9999 Derivative action time 1 (heating) [s], 2. parameter set 180
Td22
0...9999 Derivative action time 2 (cooling) [s], 2. parameter set 180
SEtP
Name Value range Description Default
SP.LO -1999...9999 Set-point limit low for Weff 0
SP.Hi -1999...9999 Set-point limit high for Weff 900
SP.2 -1999...9999 Set-point 2. 0
r.SP 0...9999 Set-point gradient [/min] OFF
SP.bo -1999...9999 Boost set-point 30
t.bo 0...9999 Boost time 10
Y.St -120...120 Start-up setpoint (see page 56) 20
SP.St -1999...9999 Set-point for start-up 95
t.St 0...9999 Start-up hold time (see page 56) 10
SP -1999...9999 Set-point (only visible with BlueControl!) 0
g
SP.Lo and SP.hi should be between the limits of rnGH and rnGL see
configuration r controller page 29
ProG
Name Value range Description Default
SP.01
-1999...9999 Segment end set-point 1 100 1
Pt.01
0...9999 Segment time 1 [min] 10 2
SP.02
-1999...9999 Segment end set-point 2 100 1
Pt.02
0...9999 Segment time 2 [min] 10 2
SP.03
-1999...9999 Segment end set-point 3 200 1
Pt.03
0...9999 Segment time 3 [min] 10 2
SP.04
-1999...9999 Segment end set-point 4 200 1
Pt.04
0...9999 Segment time 4 [min] 10 2
1 If SP.01 … SP.04 = OFF then following parameters are not shown
2 If segment end set-point = OFF then the segment time is not visible
Parameter setting level
KS50/52-1 49 Parameters