Metex 8760CLP Total Free Chlorine & pH Analyzer User Manual
Page 61
AQUAMETRIX INC.
1-800-742-1413 www.aquamerix.com
61
PASSWORD EXAMPLE - A QUICK TOUR
With security disabled, select [CONF] [PAS.2] from the menu. Set the level 2 password to “0002".
Select [CONF] [PAS.1] from the menu. Set the level 1 password to ”001." Security is now enabled.
Select [PASS] from the main menu. Press ENTER with [0000] displayed. The analyzer will display
[ACC.0] to indicate we are now at access level 0.
Try changing the output 1 low setting. Select [out] [out1] [LO] from the menu. The current value will
display. Press ENTER to go into edit mode. The analyzer will display [PASS] for 2 seconds because we
need to enter a password first. Level 1 security is needed to change this setting.
Select [PASS] from the main menu again. Change the displayed value to [0001], which is the level 1
password. Press ENTER. The analyzer will display [good], followed by [ACC.1], indicating that the
password is valid and that we now have level 1 access.
Try changing the output 1 low setting again. You will find that this time we can go into edit mode
unhindered.
Select [PASS] from the main menu again. Enter the level 2 password, which is “0002.” We are going
to set the level 2 password to “0000” again to disable password security. Password 2 is found in the
configuration menu and therefore requires level 2 access before it can be accessed. Select [CONF]
[PAS.2] from the menu. Press ENTER with [0000] displayed. Both passwords are set to “0000” again
and password security is disabled.