Metex 8760CLP Total Free Chlorine & pH Analyzer User Manual
Page 16
AQUAMETRIX INC.
1-800-742-1413 www.aquametrix.com
16
Easy to use Menu
The layout of the program is shown in the menus starting on page 3.
Remembers Where You Were
The analyzer remembers where SAMPLE is. The sample display is
home base for the program. The program also remembers which menu
selections were used last and loops around the columns. The menu can
be accessed using the arrow keys to find any parameter then press
SAMPLE to return to the displayed reading. Then, using the Right
arrow key return to exactly where you were.
Home Base: Press Sample
From anywhere in the menu, the SAMPLE key can be used to return to
displaying tFCl. The program will safely abort whatever it was doing at
the time and return to displaying the tFCl reading.
The tFCl display is the default sample display for the analyzer. The
analyzer's inputs, tFCl, HOCl, pH and temperature, are arranged
underneath each other at the left-hand side of the menu. Use the Up or
Down arrow key to display each of the readings in turn.
Display Features
1. The analyzer has a built-in timer, which returns the program to
displaying tFCl if no key is pressed for 15 minutes. This time-out has
the same effect as pressing the SAMPLE key. If security has been
enabled, then the time-out will change the access level back to 0 or 1
automatically, which gives the user read-only access. The user will
have to enter an appropriate password to go to a higher access level.
2. When the sample value is displayed, pressing the Left arrow key will
show which of tFCL, HOCl, pH or temperature is displayed. Pressing
Right arrow key displays the sample reading again.
3. The main sample, i.e. the input that is displayed first when the SAMPLE
key is pressed, can be changed. By default the main input is [tFCl].
Change the default in [CONF] [in] [dFLt]. Refer to the Configuration
of Program section for further details.
Illustration 9: Home base
Illustration 10: Main menu