Metex 8760CLP Total Free Chlorine & pH Analyzer - Manual (Page 44)

AQUAMETRIX INC.
1-800-742-1413 www.aquametrix.com
44
DISPLAY PROMPTS
[_ . _] Timer menu
[+_ . _] Set time for on-cycle
[-_ . _] Set time for off-cycle
[AL] Alarms
[AL.A] Alarm A
[AL.b] Alarm B
[Auto] Automatic compensation
[bAud] Baud rate
[buF1] Buffer for standardizing or first buffer for calibration
[buF2] Second buffer for calibration
[°C] Temperature in degrees Celsius; temperature input; use metric units
[CAL] Calibrate
[CHIP] Chip. Is this analyzer equipped with a real-time clock chip?
[CF] Membrane compensation factor
[CLSd] Normally closed alarm contact
[CONF] Configuration
[cur]
Signal output in mA, or current
[cuSt] Custom buffer value for calibration
[dA] Input damping time in seconds
[dAtE] Date. Real-time clock setting for day of month
[dEv] Deviation alarm
[dFLt] Default
[dLAY] Alarm activation delay
[do] Do — press to do reset/clear action
[donE] Done – reset/clear action has been accepted
[EFF] Efficiency
[Err] Error
[Er.94] RAM checksum failed. Some settings may be lost
[Er.95] EPROM checksum failed
[° F] Temperature in degrees Fahrenheit; temperature input; use imperial units
[FLt] Fault alarm, selectable function for alarm B
[GEt] Get the grab sample calibration reference reading
[HI] High alarm; high limit (20 mA) for 4 mA to 20 mA output window
[HOCl] HOCl, hypochlorous acid, free available chlorine input
[HOLd] Output hold
[hour] Hour. Real-time clock setting
[hund] Hundredth of a second. Real-time clock setting
[iLOG] Internal data log menu; refer to IC Net section
[in] Input – OR – Minute for real-time clock setting
[init] Initialize all program settings to factory defaults
[LO] Low alarm; low limit (4 mA) for 4 mA to 20 mA output window
[no.Cl] No chlorine alarm
[NodE] Node number
[NO.NC] Normally Open/Normally Closed
[NONE] No membrane compensation
[OFF] Off
[OFFS] Offset
[OLd] Old. The grab sample calibration old reading
[ON] On