KROHNE BM 70 M - Manual (Page 35)

BM 70 M 35
Function (Fct.) Enter range Default value Description
2.3 SW.OUTPUT
OPEN 2.3.1 TEST S Options
CLOSED
OPEN Switching output on/off.
IMPORTANT !!! With
safety inquiry because
of direct access to the
switching output !!!
2.4 FIRMWARE
2.4.1 MASTER Display Displays the firmware
version of the master.
2.4.2 DISPLAY Display Displays the firmware
version of the display.
3.0 INSTALL.
3.1 BASIS.PARAM
m
cm
mm
inch
Options,
unit
Ft
3.1.1 TANKHEIGHT
Enter
0.50 [m]...max. tank
height
M
10.00 m* /
20.00 m *
To input the tank
height.
The tank height is
defined as the vertical
distance between the
bottom edge of the
flange and the tank
bottom.
The unit entered here is
also used for all other
length inputs.
3.1.2 BLOCKDIST Enter
0.10 [m] ... tank height
0.50 m * To input the block
distance.
The block distance
marks the non-
measurable range
below the bottom edge
of the flange.
3.1.3 ANTENNA Options STANDARD STANDARD* Selection of the
antenna type.
3.1.4 ANT.EXTENS Enter
0.00 [m] ... Tank height
0.00 m * To input the length of
the antenna extension.
3.1.5 DIST.PIECE Enter
0 ... 2000 [mm]
0 mm * To input the length of
the flange distance
piece in [mm] (high-
temperature version =
120 mm).
Options NO
YES
If "YES":
Enter (restraint)
STILLWELL DIA.
3.1.6 STILLWELL
25 ... 200 [mm]
NO
100 mm
Select: with or without
stilling well. When
"YES" selected, the
inside diameter of the
stilling well is
additionally entered in
[mm].
3.1.7 REF.OFFSET Enter
-10.00 ... + 10.00 [m]
0.00 m To input the reference
offset (relocation of the
upper reference point).