KROHNE OPTIWAVE 6300C EN - Manual (Page 56)

6
OPERATION
56
OPTIWAVE 6300 C
www.krohne.com 03/2014 - 4000547004 - HB OPTIWAVE 6300 R04 en
Data dependencies for the 4 mA settings of outputs 1 and 2
C.5.1.4 Length Unit The length unit displayed in operator
mode.
m, cm, mm, inch, ft, ft-inch-
1/16inch, ft-inch-1/32inch,
Free Unit
m
C.5.1.5 Volume Unit The volume unit displayed in operator
mode.
m3, L, US gal, GB gal, ft3, bbl m3
C.5.1.6 Mass Unit The mass unit displayed in operator
mode.
Tons, Kg, US Tons, GB Tons Kg
C.5.1.7 Custom.
Length Unit
A non-standard length unit for the
conversion table. This is defined by the
supervisor.
LEN_FREE_
C.5.1.8 Custom.
Length Ratio
The conversion factor between the
length unit selected in C.5.1.4 (Length
Unit) and C.5.1.7 (Custom. Length
Unit). This ratio is a multiple of 1 mm.
min.-max: 1…99999 1
C.5.1.9 Custom. Conv.
Unit
A non-standard conversion unit for the
conversion table. This is defined by the
supervisor.
CO_FR_UN
C.5.2 C.5.2 C.5.2 C.5.2 Passwords Passwords Passwords Passwords To change user passwords, refer to To change user passwords, refer to To change user passwords, refer to To change user passwords, refer to
these menu items. these menu items. these menu items. these menu items.
C5.2.2 Supervisor This changes the supervisor password.
Push the keypad buttons up to 6 times
in any order. This will be the new
password. To confirm the change,
enter the new password a second time.
[>>>>], [^ ^ ^ ^], [ ],
[ ], [> >>>], [^ ^ ^ ^]
C.6 Reset
C.6.2 Clear Error
Record
Erase the error record in menu item
B.2.6. Push [^ ^ ^ ^] to confirm.
C.6.3 Restart If the device is not functioning properly,
this menu item will restart the device.
Push [^ ^ ^ ^] to confirm.
1 Units and range depend on the output function, length unit and volume unit selected. See also the table of data dependencies for the
4 mA settings in this section.
2 Units and range depend on the output function, length unit and volume unit selected. See also the table of data dependencies for the
20 mA settings in this section.
Output function Minimum value Maximum value Default
Level 0 m <20 mA Setting for Level 0 m
Volume 0.00 m³ <20 mA Setting for Volume 0 m³
Mass 0.00 kg <20 mA Setting for Mass 0 kg
Distance 0 m <20 mA Setting for Distance 0 m
Ullage Volume 0.00 m³ <20 mA Setting for Ullage Volume 0 m³
Ullage Mass 0.00 kg <20 mA Setting for Ullage Mass 0 kg
Menu
No.
Function Function description Selection list Default