KROHNE OPTIWAVE 6300C EN - Manual (Page 52)

6
OPERATION
52
OPTIWAVE 6300 C
www.krohne.com 03/2014 - 4000547004 - HB OPTIWAVE 6300 R04 en
C. Advanced setup
B.2.3 Device ID This displays device order no, V-no,
service no, Ex approval, Main CPU
version, Companion CPU version and
DSP version.
Read only
B.2.4 Quick Setup
Sum.
A summary of the parameters entered
in the quick setup menu
Read only
B.2.5 TAG number The TAG number can be seen and
updated here
? TAGNO0123
4567890
Temperature Temperature of the electronics block.
The display will automatically switch
off if the temperature is below -20°C /
-4°F or above +60°C / +140°F.
Read only
B.2.6 Error Records A log of device errors. Scroll down the
list and push [^ ^ ^ ^] to display the error
details. Opening a log will remove the
error icon if it appeared in operator
mode.
Read only
Measurement
Quality
Status of device errors at this time. A
"tick" symbol next to an error in the list
shows that this error is active and may
have an unwanted effect on the device.
Read only
B.2.7 Custom.
Length Unit
Non-standard length unit for the
conversion table. This is defined by the
supervisor. Go to Supervisor > Supervisor > Supervisor > Supervisor >
Advanced Setup > Device Setup > Advanced Setup > Device Setup > Advanced Setup > Device Setup > Advanced Setup > Device Setup >
Display Settings > Custom. Length Unit Display Settings > Custom. Length Unit Display Settings > Custom. Length Unit Display Settings > Custom. Length Unit
or follow the procedure in the
Conversion Conversion Conversion Conversion setup menu.
Read only
B.2.9 Custom. Conv.
Unit
Non-standard conversion unit for the
conversion table. This is defined by the
supervisor. Go to Supervisor > Supervisor > Supervisor > Supervisor >
Advanced Setup > Device Setup > Advanced Setup > Device Setup > Advanced Setup > Device Setup > Advanced Setup > Device Setup >
Display Settings > Custom. Conv. Unit Display Settings > Custom. Conv. Unit Display Settings > Custom. Conv. Unit Display Settings > Custom. Conv. Unit
or follow the procedure in the
Conversion Conversion Conversion Conversion setup menu.
Read only
Menu
No.
Function Function description Selection list Default
C.1 Installation Setup
C.1.1 Installation
Type
The installation on the silo for the
device.
Metal / concrete silo, Plastic
silo, Free Air Application
Metal /
concrete silo
C.1.2 Tank Height /
Measuring
Range
"Tank height" is the distance from the
silo connecting flange face/thread stop
to the silo bottom. "Measuring range"
(for "Free Air Application" only) is the
maximum distance that the device
must measure.
min-max:
0.20…80 m / 0.66…262 ft
20 m / 65.61 ft
C.1.3 Application
Type
The conditions in which the device is
used. If the surface of the product is
flat, select "Flat surface". If there is a
slightly uneven surface, select
"Medium slope". If the surface has a
steep slope, select "Steep slope".
Flat surface, Medium slope,
Steep slope
Medium slope
C.1.4 Stillwell Height Not available. For liquid applications
only.
n/a n/a
Menu
No. Function Function description Selection list Default