GW Instek GDS-2000 training manual - Manual (Page 34)

GDS-2000 Series Training Manual
34
G
LA-1000 ADVANCED
Using the demo board, you can verify the advanced bus analysis
feature in GLA series. By using GDS-2000 and GLA series together,
you can also observe how to trigger on ripple counter.
Required tools
 Demo board x 1
 GLA-1000 series x 1
 USB type A – type B x1 cable for demo board power supply
 GDS-2000 x 1 (only for DAC simulation demo)
 Standard oscilloscope probe x 1 (only for DAC simulation demo)
Demonstration type
 DAC simulation  I 2 C bus analysis
 SPI bus analysis  UART analysis
How to run demonstration
1. Setup the demo board and logic analyzer according to page36.
2. Pick up the demonstration topic and run it.
Note
The demonstration is applicable to GLA series firmware version 2.03
or later.