beautypg.com

Gds-2000 demonstration setup – GW Instek GDS-2000 training manual User Manual

Page 20

background image

GDS-2000 Series Training Manual

20

GDS-2000 Demonstration Setup

Follow the below steps to properly power up and connect the demo
board. Use step 5 ~ 8 to reset the board after each demonstration.

1. Power up GDS-2000.

2. Connect the USB cable to the demo board and GDS-2000 rear

panel USB connector.

3. Select x10 as attenuation level, for both CH1 & CH2 probe.

4. Connect the probes between GDS-2000 CH1&2 and the Sine

wave terminal on the demo board.

CH1

CH2

FM

Sin

Make sure the ground clips are connected to the ground plane.

5. Press the Save/Recall key → F1 to reset the system.

Save/Recall

Default

Setup

F 1