GW Instek GRF-1300A - Manual (Page 11)

Introduction to the GRF-1300A
LO-IF ≥-35dBm
Mixer+modulation ≥-60dBm
Bandpass Filter
Frequency Centre:
2.4GHz
Bandwidth:±20MHz
Communication
Turn circuits on or off by remote command for
the diagnostic experiments.
Usage Instructions
1. For safety purposes, please connect the unit to the correct AC
power source: 100V~240V,
50-60Hz.
Make sure the ground terminal is properly earthed to prevent
electric shock.
2. The power socket and USB port are on the rear panel. The
power switch is on the upper
left-hand side of the device.
USB port AC socket Power switch
Procedure
3. When using several modules together at the same time,
connect each module with the appropriate RF cable.
Figure A-3.
Connection
diagram between
different modules
4. The UP and DOWN buttons on the Baseband module can be
9