GW Instek GDS-122 User Manual User Manual

Page 37

Using

the

Oscilloscope

2. Hold the mouse and drag the waveform

sideways.

Changing the vertical position

Click the channel label at the left side of the
waveform and drag the waveform up or down.

Changing the

waveform scales

Before changing the scales, make sure that the
correct waveform is selected (highlighted) in the
lower left corner of the screen (example: CH1).

Changing the horizontal scale

Select the horizontal scale using
the list at the right side of the
screen. You can select the scale
either by searching in the Scale
column or by clicking the
Position arrows.

GDS-122 User Manual

Changing the vertical scale

Select the vertical scale using
the list at the right side of the
screen. You can select the scale
either by searching in the Scale
column or by clicking the
Position arrows.

Viewing the

automatic

measurement

results

Before viewing the measurement results, make
sure that the correct waveform is selected
(highlighted) in the lower left corner of the screen
(example: CH1).

The measurement result
is updated in the lower
right corner of the
screen. Three parameters
are listed.

•

Period: measures the waveform period in ms.

•

Freq: measures the waveform frequency in
kHz.

•

PK‐PK: measures the peak to peak voltage in V.