Afety, Nstructions – GW Instek GDS-122 User Manual User Manual
Page 3
TABLE
OF
CONTENTS
5
Measuring Voltage ................................................... 85
Measuring Current ................................................... 87
Measuring Impedance ..............................................
69H
89
Measuring Diode .....................................................
70H
91
Measuring Continuity ...............................................
71H
92
Measuring Capacitance ............................................
72H
93
Faq.............................................................
73H
95
Specifications..............................................
74H
97
Oscilloscope specifications ..........................................
75H
97
Multimeter specifications .............................................
76H
98
General specifications ..................................................
77H
99
Declaration of Conformity ..........................
78H
100
Index........................................................
79H
101
GDS-122 User Manual
6
S
AFETY
I
NSTRUCTIONS
This chapter contains important safety instructions
that you should follow when operating the
instrument and when keeping it in storage. Read
the following before any operation to ensure your
safety and to keep the instrument in best condition.
Safety Symbols
These symbols may appear in this manual or on the instrument.
WARNING
Warning: Identifies conditions or practices that
could result in injury or loss of life.
CAUTION
Caution: Identifies conditions or practices that
could result in damage to the instrument or to
other properties.
DANGER: High Voltage
Attention: Refer to the Manual
Protective Conductor Terminal
Earth (ground) Terminal
Safety Guidelines
General
Guidelines
CAUTION
•
Do not place heavy objects on the instrument.
•
Avoid severe impacts or rough handlings that
may damage the instrument.
•
Avoid discharges of static electricity onto or
near the instrument.
•
Do not insert bare wires or metal objects into
the terminals.
•
Do not apply input voltage more than 42V
peak (30Vrms) to the instrument.