Set up & probe compensation – GW Instek GOS-630FC User Manual

Page 13

SETUP

CH1/CH2
VARIABLE
Knob

CAL

CH1/CH2
Coupling
Switch

Trigger
SOURCE Switch

CH1

Trigger SLOPE
Switch

+ (Positive slope)

TRIG ALT
Switch

Released (alternating trigger
disabled)

Trigger MODE
Switch

AUTO

TIME/DIV
Knob

0.5ms/DIV

Horizontal
SWP.VAR Knob

CAL

Horizontal
POSITION
Knob

Center of the display

x10 MAG
Switch

Released (x10 maginification
disabled)

GOS-630FC

User

Manual

Set up & Probe Compensation

Follow these steps and properly set up the oscilloscope, make sure it
is functional, and compensate the probe.

1 Power

on Press the Power switch and turn

on the oscilloscope’s power. The
LED lights when the power is on.
The trace line starts to appear after
20 – 30 seconds.

2 Intensity

and focus
adjustment

Use the INTEN knob and FOCUS
knob to adjust the trace line
appearance to the best condition.

3 Probe

connection

Connect the probe between the
CAL output and the CH1 input
terminal. Select x10 (attenuation)
on the probe.

Select x10 (attenuation) on the probe.

4 Probe

attenuation

5 Coupling

mode
selection

Select the AC position in the CH1
AC‐DC‐GND switch. A square
waveform appears in the display.