Seed Hawk Raven 2011 - Manual (Page 67)

3
Manual No. 016-3001-003 57
CAN (Controller Area Network) Setup
Alarms
The Viper Pro displays various alarms depending upon the conditions programmed into the console. Specific
warning boxes display when the conditions for the alarm are met. In addition to the warning boxes, the Product
Control area of the main screen displays a ‘Warning’ symbol instead of the ‘Thumbs Up’ symbol.
The CAN Controller Status screen also displays a Current Alarms button at the bottom of the screen if an
alarm condition is active.
Note:
Off Rate and Low Limit alarms will automatically clear once the condition has corrected itself. All
other alarms will need to be cleared by pressing the clear alarms button.
Once you have corrected the condition that caused the alarm, the ‘Thumbs Up’ symbol displays. To see the
current alarms for the system, press the Current Alarms button. The Current CAN Node Alarms screen
displays:
To clear all the current alarms, press the Clear Alarms button.
Note:
Pressing the Clear Alarms button will clear the current system alarms, but the alarm condition may
still be present and may need to be corrected.