Product chaining – Seed Hawk Raven 2011 User Manual
Page 137
CHAPTER
6
Manual No. 016-3001-003
127
Chapter 6
Product Chaining
The product chaining feature allows the operator to chain a group of product together. As the volume of product
remaining in the first product bin falls below five percent, Viper Pro will automatically switch from the bin to the
next available product in the chain sequence. This feature makes it possible to use multiple product bins during
an application and reduce trips to a tender truck.
Product chaining is enabled during the setup of a new job and cannot be enabled if the job is already started.
Note:
The product chaining feature is not available with ground drive SCT Ready systems.
Enabling Product Chaining
1.
Follow the instructions in the Starting a New Job section on page 117.
2.
When you get to the Product Selection screen, select the ‘Enable Product Chaining’ option. The Product
Selection screen allows the user to enter the number of products that will be applied, as well as enable the
product chaining option.
3.
Touch Next. The Product Chain Setup screen displays.