Seed Hawk Raven 2011 - Manual (Page 204)

Chapter 11
194 Seed Hawk™ Viper Pro™ Installation & Operation Manual
Job Error Messages
Variable Rate Control (VRC) Error Messages
Issue Possible Cause Solution
Open New Job error
• For non-VRC (Variable
Rate Control) jobs, you
must have GPS coverage
before starting the job
• Check for GPS signal.
No GPS Coverage
Warning: You must
have GPS coverage
if you start a non-
VRCjob.
• Displays when starting a
job without a GPS signal
• Check for GPS Signal.
Missing Product
Information: No
Product Name
Entered
• No product name
entered
• Enter a least one character for a product name.
Job is opened in
View mode only.
• Existing job was started
in View mode only. No
changes can be saved. • Close the job and restart in 'Add to Job' mode.
You must set up the
section information
in the Setup menu
• When starting a job, this
message displays if the
sections have not been
setup
• Configure the section information in the Setup menu.
You have not set up
all of the products
for this job
• You have not entered the
information for all of the
products during the job
setup routine. • Make sure that all products have an assigned product
name.
You must select at
least 1 section for
this product
• Every product in the
system must have at
least one section
assigned to it. • Using the Section Select option, check at least one
section for the product.
The Section
Settings for this job
do not match your
current section
setup. Cannot add
to this job.
• When adding to an
existing job, all section
settings must match
exactly the section
configuration when the
job was originally started.
• Re-configure your section setup to match the
configuration when the job was originally started.
Issue Possible Cause Solution
Browse Rx Files
• VRC must be selected in
order to enter
prescription information • Select VRC in the Product Setup screen.
VRC must be
selected in order to
enter prescription
information
• VRC was not selected
during the product setup
• Select VRC in the Product Setup screen.
No VRC Products
• There are no more
selections to make
• Press OK to start the job.