Brocade DCX 8510-4 Backbone Hardware Reference Manual - Manual (Page 63)

Vertical cable management fingers removal and replacement
The Brocade DCX 8510-4 comes equipped with two vertical cable management finger assemblies. It
can continue to operate during the replacement of the cable management fingers. Due to the horizontal
orientation of the blades in the Brocade DCX 8510-4, the finger assemblies are attached to the uprights
of the mounting rack.
Time and items required
The replacement procedure for the cable management fingers takes less than five minutes. A #1
Phillips screwdriver is required.
Removing a cable management finger assembly
Complete the following steps to remove the cable management finger assembly.
1. Remove the chassis door.
2. Remove the cables from the cable management finger assembly and rearrange the cables around
the assembly.
3. Unscrew and save the three (3) screws holding the finger assembly to the rack upright. Support the
assembly to prevent it from falling.
4. Remove the cable management finger assembly.
5. If necessary, repeat steps 1 through 4 for the other finger assembly.
Vertical cable management fingers removal and replacement
Brocade DCX 8510-4 Backbone Hardware Reference Manual 63
53-1002177-07