Brocade DCX 8510-4 Backbone Hardware Reference Manual - Manual (Page 107)

NOTE
Do not route cables in front of the air exhaust vents.
Verifying correct configuration of the fabric
Copying the command outputs from this section into a file is recommended.
1. Create an "after" SAN profile by entering the following commands and copying the output to a text file
named SANafter.txt:
• nsShow
• nsAllShow
• switchShow
• fabricShow
• lscfg --show (if using the Virtual Fabric feature)
switch:admin> nsshow
Type Pid COS PortName NodeName TTL(sec)
N 020f00; 3;10:00:00:01:73:00:29:46;10:00:00:01:73:00:29:46; na
Fabric Port Name: 20:0f:00:60:69:90:03:f0
switch:admin> nsallshow
{
020f00 021fda 021fdc 021fe0 021fe1
5 Nx_Ports in the Fabric}
switch:admin> switchshow
switchName: rsl8-st03-dcx-01
switch:admin> fabricshow
Switch ID Worldwide Name Enet IP Addr FC IP Addr Name
switch:admin>lscfg --show
Created switches: 128(ds) 1 2(bs)
Port 0 1 2 3 4 5 6 7 8 9
-------------------------------------------------------------------
FID 1 | 1 | 1 | 1 | 1 | 128 | 128 | 128 | 128 | 128 |
switch:admin>
2. Determine any differences between the information in the SANafter.txt file and the information in the
SANbefor.txt file created earlier. In particular, look for differences in the following:
• Device types
• Number of devices
• ISL and port states
• Number of switches in the fabric
3. Resolve any issues or unintentional changes to the Brocade DCX 8510-4 or fabric:
• If there are any mechanical problems, try reseating the associated component.
• If the configuration information is not correct for the Brocade DCX 8510-4, modify as required.
• If other issues exist, contact your support provider.
Cable routing table
The following table is a 64-port template for a cable routing table. Make copies of the table to cover the
total number of ports in the Brocade DCX 8510-4.
Verifying correct configuration of the fabric
Brocade DCX 8510-4 Backbone Hardware Reference Manual 107
53-1002177-07