Brocade DCX 8510-4 Backbone Hardware Reference Manual - Manual (Page 60)

Messages that may indicate WWN card failure (Continued) TABLE 9
Type of message Sample error message
WWN unit is being faulted.
0x24c (fabos): Switch: switchname, Critical EM-
WWN_UNKNOWN, 1, Unknown WWN #2 is being
faultedor, [EM-1003], 40, SLOT 7 | FFDC |
CHASSIS, CRITICAL, Brocade_DCX, WWN 2 has unknown
hardware identifier: FRU faultedor,
[EM-1034], ,, ERROR, ,
WWN # set to faulty, rc=
WWN unit is not present or is not
accessible.
0x24c (fabos): Switch: switchname, Error EM-
WWN_ABSENT, 2, WWN #1 not presentor,
[EM-1036], ,, WARNING,
name>, is not accessible.
Writing to the FRU history log
(hilSetFruHistory) has failed.
0x24c (fabos): Switch: switchname, Error EM-HIL_FAIL,
2, HIL Error: hilSetFruHistory failed, rc=-3 for SLOT
3
WWN unit insertion was detected.
, [EM-1049], ,, INFO,
, FRU WWN # insertion detected.
WWN unit removal was detected.
, [EM-1050], ,, INFO,
, FRU WWN # removal detected.
The following figure displays the WWN bezel (logo plate). The WWN cards are under the bezel.
FIGURE 18 WWN bezel (logo plate) for DCX-4S and DCX 8510-4
Monitoring System Components
60 Brocade DCX 8510-4 Backbone Hardware Reference Manual
53-1002177-07