Brocade Fabric OS Encryption Administrator’s Guide Supporting NetApp Lifetime Key Manager (LKM) and KeySecure Storage Secure Key Manager (SSKM) Environments (Supporting Fabric OS v7.2.0) - Manual (Page 80)

62 Fabric OS Encryption Administrator’s Guide (LKM/SSKM)
53-1002925-01
Configuring hosts for encryption targets
2
Configuring hosts for encryption targets
Use the Encryption Target Hosts dialog box to edit (add or remove) hosts for an encrypted target.
NOTE
Hosts are normally selected as part of the Configure Switch Encryption wizard, but you can also edit
hosts later using the Encryption Target Hosts dialog box.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 6 on page 14.)
2. Select a group, switch, or engine from the Encryption Center Devices table that contains the
storage device to be configured, then select Group/Switch/Engine > Targets from the menu
task bar.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays. (Refer to Figure 45 .)
FIGURE 45 Encryption Targets dialog box
3. Select a target storage device from the list, then click Hosts.
The Encryption Target Hosts dialog box displays. (Refer to Figure 46 .) The Hosts in Fabric table
lists the configured hosts in a fabric.
The table displays the following information:
• Port WWN: The world wide name of the host ports that are in the same fabric as the
encryption engine.
• Node WWN: The world wide name of the host nodes that are in the same fabric as the
encryption engine.
• Port Name: The name of the hosts that are in the same fabric as the encryption engine.
• Port ID: Displays the 24-bit port ID (PID) of the host port in both the Host Ports in Fabric
table and the Selected Hosts table.