Brocade Fabric OS Encryption Administrator’s Guide Supporting NetApp Lifetime Key Manager (LKM) and KeySecure Storage Secure Key Manager (SSKM) Environments (Supporting Fabric OS v7.2.0) - Manual (Page 278)

260 Fabric OS Encryption Administrator’s Guide (LKM/SSKM)
53-1002925-01
Moving an encryption switch from one EG to another in the same fabric
6
Moving an encryption switch from one EG to another in the same
fabric
In this example, which is represented in Table 17 , you have two EGs, each containing two nodes.
You want to move FOS2 from EG1 to EG2.
1. Enter the following command on FOS1 to reclaim the VI/VT WWN base for the Brocade
Encryption Switch to be moved out of EG1.
Admin:switch> cryptocfg --reclaimWWN -membernode
When prompted, answer yes.
2. Enter the following command to propagate the change throughout the EG:
Admin:switch> cryptocfg --commit
3. Enter the following command in FOS1 to eject node FOS2 from the EG:
Admin:switch> cryptocfg --eject -membernode
4. Enter the following command on FOS1 to deregister the ejected node from the encryption
group:
Admin:switch> cryptocfg --dereg -membernode
5. Enter the following command on FOS2 to clean up the encryption configuration on the
deregistered node:
Admin:switch> cryptocfg –-reclaimWWN –cleanup
When prompted, enter yes to each prompt.
6. Add FOS2 as a member node to EG2.
TABLE 17 Moving a Brocade Encryption Switch from one EG to another EG
Encryption group Nodes (before move) Nodes (after move)
EG1 FOS1 (GL)
FOS2 FOS1 (GL)
EG2 FOS3 (GL)
FOS4 FOS3 (GL)
FOS4
FOS2