Brocade Fabric OS Encryption Administrator’s Guide Supporting NetApp Lifetime Key Manager (LKM) and KeySecure Storage Secure Key Manager (SSKM) Environments (Supporting Fabric OS v7.2.0) - Manual (Page 107)

Fabric OS Encryption Administrator’s Guide (LKM/SSKM) 89
53-1002925-01
Rekeying all disk LUNs manually
2
Viewing disk LUN rekeying details
You can view details related to the rekeying of a selected target disk LUN from the LUN Re-keying
Details dialog box.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 6 on page 14.)
2. Select a group, switch, or engine from the Encryption Center Devices table, then select
Group/Switch/Engine > Targets, or right-click the group, switch, or engine and select Targets.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays.
3. Select a Target storage device, then select Group/Switch/Engine > Disk LUNs.
The Encryption Target Disk LUNs dialog box displays. (Refer to Figure 69 .) Initially the list is
empty. You must add LUNs manually.
FIGURE 69 Encryption Target Disk LUNs dialog box
4. Click Add.
The Add Disk LUNs dialog box displays. This dialog box includes a table of all LUNs in the
storage device that are visible to the hosts.
5. Click Re-keying Details.
The LUN Re-keying Details dialog box displays. The dialog box contains the following
information:
• Key ID: The LUN key identifier.
• Key ID State: The state of the LUN rekeying operation.
• Encryption Algorithm: The algorithm of the LUN rekeying operation.
• Re-key Session Number: The session number of the LUN rekeying operation.
• Re-key Role: The role of the LUN rekeying operation.