Section – Brocade Fabric OS Encryption Administrator’s Guide Supporting NetApp Lifetime Key Manager (LKM) and KeySecure Storage Secure Key Manager (SSKM) Environments (Supporting Fabric OS v7.2.0) User Manual
Page 246
228
Fabric OS Encryption Administrator’s Guide (LKM/SSKM)
53-1002925-01
Encryption group merge and split use cases
6
6. Verify your encryption group is re-converged.
Node181:admin-> cryptocfg --show -groupcfg
Node182:admin-> cryptocfg --show -groupcfg
Both nodes will now show a two node CONVERGED EG in which Node182 is the group leader
ode and Node181 is a member Node.
The above manual configuration recovery procedure will work nearly identically for all combinations
of EG split scenarios. Simply perform the following steps for the other scenarios:
•
Pick one EG/EG Leader to be maintained.
•
Using that GL Node, deregister all Nodes which are in a DISCOVERING state as determined by
the output of the cryptocfg
--
show
-
groupmember
-
all command.
•
Go to the other EG islands and delete the EGs.
-
In the one case where the other EG has a member node which is in a DISCOVERED state,
you will first need to eject that DISCOVERED Node prior to being allowed to delete that
other EG.
•
From the only remaining EG/EG leader, reregister the previously deregistered Nodes.
•
Confirm the EG is converged.
Configuration impact of encryption group split or node isolation
When a node is isolated from the encryption group or the encryption group is split to form separate
encryption group islands, the defined or registered node list in the encryption group is not equal to
the current active node list, and the encryption group is in a DEGRADED state rather than in a
CONVERGED state.
list configuration changes that are allowed and disallowed
under such conditions
.
TABLE 7
Allowed Configuration Changes
Configuration Type
Allowed configuration changes
Encryption group
•
Adding a node to the encryption group
•
Removing a node from the encryption group
•
Invoking a node leave command
•
Deleting an encryption group
•
Registering a member node (IP address, certificates)
HA cluster
•
Removing an encryption engine from an HA cluster
•
Deleting an HA cluster
Security & key vault
•
Initializing a node
•
Initializing an encryption engine
•
Re-registering an encryption engine
•
Zeroizing an encryption engine