Brocade Fabric OS Encryption Administrator’s Guide Supporting NetApp Lifetime Key Manager (LKM) and KeySecure Storage Secure Key Manager (SSKM) Environments (Supporting Fabric OS v7.2.0) - Manual (Page 228)

210 Fabric OS Encryption Administrator’s Guide (LKM/SSKM)
53-1002925-01
Encryption group and HA cluster maintenance
6
Encryption group and HA cluster maintenance
This section describes advanced configuration options that you can use to modify existing
encryption groups and HA clusters, and to recover from problems with one or more member nodes
in the group.
All group-wide configuration commands are executed on the group leader. Commands that clear
group-related states from an individual node are executed on the node. The commands require
Admin or SecurityAdmin permissions.
Displaying encryption group configuration or status information
You can use the - -show
-
egstatus command to display encryption group configuration information
and encryption group status information.
•
--
show
-
egstatus
-
cfg Displays encryption group configuration information.
•
--
show
-
egstatus
-
stat Displays encryption group status information.
Removing a member node from an encryption group
This procedure permanently removes a member node from an encryption group, as shown in
Figure 99 . Upon removal, the HA cluster failover capability and target associations pertaining to the
node are no longer present. To remove a node from a group without disrupting these relationships,
use the cryptocfg
--
replace command. Refer to the section “Replacing an HA cluster member” on
page 215 for instructions.