Brocade TurboIron 24X Series Hardware Installation Guide - Manual (Page 65)

Brocade TurboIron 24X Series Hardware Installation Guide 55
53-1002981-01
Power supply specifications
A
Power cords
All Brocade devices ship with US-compatible power cords unless otherwise specified at the time of
order. United Kingdom- and European-compatible power cords are also available.
For power cord specifications, refer to “Input connector and plug” on page 57.
Power supply specifications
This section contains the following information for the power supplies that ship with TurboIron 24X
devices.
• “Overview”
• “Key features”
• “Physical dimensions and weight”
• “Environmental considerations”
• “Power supply consumption”
• “Input connector and plug”
• “Regulatory compliance”
• “Safety warnings”
• “Electrical specifications”
Overview
Each TurboIron 24X switch comes with two alternating-current (AC) power supplies. The following
power supplies may be installed in your TurboIron 24X switch:
• RPS-TI24X (AC power supply)
The power supplies can be swapped in or out of the device while the device is running, without
opening the device. You can remove one of the power supplies without interrupting operation. The
remaining power supply provides enough power for all the ports.
CAUTION
Remove the power cord from a power supply before you install it in or remove it from the device.
Otherwise, the power supply or the device could be damaged. The device can be running while a
power supply is being installed or removed, but the power supply itself should not be connected
to a power source.
All power supplies are auto-sensing and auto-switching.
Key features
Refer to “Power supplies” on page 6 for the key features of the TurboIron 24X power supplies.