Brocade TurboIron 24X Series Hardware Installation Guide - Manual (Page 11)

Brocade TurboIron 24X Series Hardware Installation Guide 1
53-1002981-01
Chapter
1
Product Overview
This chapter contains the following sections:
• Product overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
• Software features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
• Hardware features. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Product overview
TurboIron 24X provides high port density and 512 MB of DDR RAM when shipped from the factory.
TurboIron 24X delivers a full complement of standards-based, feature-rich Layer 2 switching
capability. The extensive feature set supports network requirements ranging from basic
connectivity to multicast- enabled full streaming audio and video applications for converged
services.
The TurboIron 24X supports:
• Twenty-four SFP+ ports at either 1 GbE or 10 GbE using the standard E1MG optics, as well as
the new SFP+ 10GbE optics
• Four 10/100/1000 RJ-45 ports
Software features
Software features differ depending on the software version that is loaded on the device. When first
shipped, the TurboIron devices support full Layer 2 Switching.
For a complete list of software features supported on the TurboIron, refer to the release notes or
the TurboIron Configuration Guide.
Hardware features
This section describes the physical characteristics of the Brocade TurboIron models. For details
about physical dimensions, power supply specifications, and pin-outs, refer to
Appendix A,
“Hardware Specifications” .